Page 51 - Tridekon Extractor Intro

45
24.Bag Clean-Up:
When fnishing the bag, follow this proce-
dure:
a. Shut PTO off.
b. Stop fow of pressurized oil to the
wheels by opening the relief valve com-
pletely.
c. Let the rollers pull most of the remain-
der of the bag (leave last 10 feet [3 m])
through the machine.
d. Cut open the last 10 feet (3 m) of the
bag.
e. Tilt the machine slightly to raise the
pick-up assembly about a foot off the
ground.
f. Turn the rollers backward to provide
some slack to the bag to work around.
g. Cut the front section of the bag off at
the gathering rollers..
h. Drive tractor forward 3 feet (1 m) and
lower the pick-up assembly to its down
position.
i. Turn tractor off and set park brake.
j. Install the covers over each side of the
pick-up assembly.
k. Start the tractor and engage PTO. Run
the engine at mid RPM.
l. Use a scoop shovel to pick up remain-
ing grain from the bag and put it into the
hoppers.
m. When grain is cleaned up, stop PTO.
n. Remove bag.
o. Fold up machine.
p. Install top auger braces.
q. Install bottom auger support braces.
r. Move to next location.
Fig. 44 FINISHING
Finishing the Bag
Cut Open Bag
Opened Bag
Cut Off Bag